The microHam Micro-R (aka u2r) station controller is intended for all radio amateurs with two radios and any soundcard interface. Despite the many functions the microHAM u2R is easy to install and operate. The provided functions are for example manual or automatic switching of microphone, headphone, CW key and PTT to each radio, control of a band (antenna) switch and much more. The microHAM u2R is supported by many contest programs in automatic mode.

The microHAM u2R is a controller for two radios and offers everything you need for Single-Op, Two-Radio (SO2R) contest operations. Just install the supplied software, connect your microphone, key, foot switch and headphones to the controller, connect the radios - and go! All controls are easy to operate and conveniently located at the front panel. With the push of a button you select which audio (Radio 1 or 2 or both) you hear, same as which radio receives the transmit audio from the soundcard. or you let the software select this automatically for you, which is very helpful during a contest. The telegraphy keying is done with a K1EL Winkey2 chip, assuring precise and accurate keying of the transmitter. Several LEDs show the current state of the microHAM u2R controller.

Unlike any other commercially available SO2R solution (except MK2R and MK2R+ from microHAM), micro2R uses either USB or LPT control, includes a proven WinKey2 CW keyer, support for either electret or dynamic microphones, a UART compatible FSK port for each radio, and built-in support for the voice keyer capabilities of the most popular contesting software.

L'interfaccia microHAM DXP utilizza un convertitore AD a 24 bit per digitalizzare il segnale audio ricevuto. Anche la successiva elaborazione dei dati avviene con questa altissima risoluzione. Il risultato è un campo dinamico molto più ampio, cioè la capacità di rilevare in modo sicuro ed affidabile anche segnali molto bassi in presenza di segnali molto forti quindi una migliore decodifica anche in condizioni difficili, ad esempio con un numero molto elevato di segnali FT-8 allo stesso tempo. Questa risoluzione molto alta è particolarmente utile per segnali modulati in fase come FT-8, JT65 o PSK-31.

Un'altra innovazione di microHAM è l'uso di USB conforme agli standard, questo significa che il DXP non richiede più i propri driver sui sistemi operativi attuali, in quanto questi sono già tutti disponibili. Questo vale per Windows a partire dalla versione 7 e per le attuali versioni di MacOS e Linux. Il software 'urouter' precedentemente comune di microHAM non è più necessario, l'impostazione viene effettuata tramite il display OLED di facile lettura sull'interfaccia DXP. Come ulteriore semplificazione, il produttore ha sostituito i ponticelli precedentemente comuni con interruttori elettronici, in questo modo si elimina la necessità di aprire l'interfaccia DXP e può essere facilmente utilizzata con diverse radio. Per il collegamento alla radio sono disponibili cavi già pronti per più di 20 diversi tipi di ricetrasmettitori.

L'interfaccia DXP può fare di più che i soli modi digitali come RTTY e FT-8 la DXP ha anche un'interfaccia CAT con convertitore di livello per tutti i comuni tipi di radio. Anche in questo caso viene utilizzato il conseguente isolamento galvanico tra radio e computer che assicura che non si verifichino loop di ronzio, inoltre è installato l'ultimo chip WinKey di K1EL, in modo da rendere facile e precisa la trasmissione in telegrafia. La memoria del manipolatore è accessibile senza problemi tramite i grandi pulsanti sulla parte superiore del DXP, inoltre c'è la possibilità di collegare un manipolatore USB esterno. Naturalmente è possibile utilizzare anche una tastiera per la telegrafia. Un ingresso e un'uscita PTT offrono ciascuno tutto il necessario per l'integrazione nella propria stazione,

E ancora una volta - tutto in un solo controller,ma ora per due radio ! Il dispositivo ideale per tutti i radioamantori che hanno piu' di una radio. E anche particolarmente adatto per le operazioni in Single-Op/2 Radio (SO2R) durante i contest.

MK2R+™ e' il piu' potente All-In-One multi-mode controller per due radio per CW, SSB, AM, FM, e i modi digitali (RTTY, PSK31, SSTV e molti altri) progettato per i piu' seri operatori di contest o DXer con due transceivers. MicroKEYER 2R include l'interfaccia per il controllo del rig per supportare due radio (Elecraft, Icom, JRC, Kenwood, Ten-Tec, and Yaesu), uscite PTT indipendenti sia per l'LNA e il Power Amplifier control, un WinKey CW Keyer migliorato e di seconda generazione, e un audio switching per la ricezione e la trasmissione. MicroKEYER 2R Plus comprende anche un unico ,, dual codec sound system per l'audio processing.

Il kit completo contiene: MK2R™ o MK2R+™, cavo USB cable,cavo LPT , due (2) cavi audio stereo, cavo per le cuffie terminato con due plug (2) 6.3 mm (1/4”) , due (2) 3.5 mm (1/8”) , un (1) coassiale 2.1mm/5.5 mm power plug, due (2) cavi da RCA a RCA , e un CD-ROM con il programma e la documentazione del microHAM USB Device Router. Offriamo un 10 tasti tastiera MK-KEYPAD opzionale, vedi sotto.

The micro KEYER III is the first station controller with a 24 bit sound architecture for all modes. Regardless which mode you use - phone, morse or digimodes, everything which can be done with the sound card benefits from this new 24 bit system. The micro KEYER III makes it work.

The built-in 24 bit USB sound card offers various benefits: for one it has and again much better signal to noise ratio than other simple sound devices and also in comprision to the predecessor MK-2; on the other hand this technology offers a much larger dynamic range. Both these enhancements provide a better decoding even of weak signals like you find them for example at EME and FT-8 modes. A general benefit of such an interface is the fact, that the internal soundcard of the computer remains free for it's traditional purposes - playing sound from the operation system or video. You only need one cable from the interface to the computer - everything including the audio signals are carried by the single USB cable. The 24 bitUSB soundcard of the micro KEYER III has two separate channels, supporting transceivers with two separate audio outputs (like one for main and one for sub receiver).

Here are the possibilities of the new micro KEYER III in in particular. Changes and enhancements to the predecessor are marked like this .

The microHAM Station is the successor to the popular Band-Decoder, and offers a lot of additonal functions. With the Station you integrate a lot of devices of your shack: automatic antenna switching with the freely programmable band decoder, computer controlled rotator direction,, CAT control of your radio, switching of bandpass filters, a sequencer for amplifiers and last but not least the integration of your SteppIR antenna. With the iLink connection you can further integrate your existing soundcard interface by microHAM: works with Micro-Keyer, Micro-Keyer2, Digi-keyer, Micro-Keyer2R(+) etc.

The most control functions are derived from frequency and PTT information. This offers you 20 frequency dependent output switches to control an antenna switch (for example). Some antennas can be declared as receive only antenna, the Station will block transmitting on these antennas. Additionally a freely programmable sequencer is availabkle, for example to control the delayed switching of pre amplifiers or amplifiers.

The intelligent rotor control allows the use of nearly any rotor manufacturer and type. The position information may be an analog voltage (e.g. Yaesu, Hy-Gain) or a digital pulse (e.g. SPID). Depending on band and your individual setup the antenna will turn automatically, for example after entering just the prefix of a call or a locator (depending on your log program).

Several fixed antennas can be grouped into a 'virtual rotr', selecting the right antenna depending of the destination. This can be used with antennas like 4-Squares or Beverages.

If you use a SteppIR or Ultrabeam antenna, this can also be controlled by the Station. This has several benefits. A SteppIR antenna directly coupled to your transceiver would follow each and every frequency change, even when another antenna is in use. The Station transmits control information to the variable antenna only if it also the active antenna. Another benefit is that large split offsets can be compensated, the antenna will not retune between Tx and Rx.

With the clearly arranged controls of the Station , practically all functions can be controlled from the front panel. This makes the operation independent of a computer, provided the band limits and setup has been programmed once before.

The built-in CAT interface allows to connect nearly any radio to the computer and the log software. Already existing microHAM interfaces can be integrated with the iLink port. The required 'iLink' cable (both sides 6p MiniDIN,

The Station Deluxe is the big brother of the regular Station and have not only all of his skills, but offers the ergonomic user interface with a large 240x64 LC Display, programmable controls also support for stacked antenna systems.

The Station Deluxe is designed for large single amateur radio stations with multiple rotors and stacks, and for SO2R stations which require full control of all operations with a comfortable, ergonomic operation. Of course, the Station Deluxe also excellent at multi - used stations.

The network capability makes the Station Deluxe something special. Several Station Deluxe can be connected via the the trusted "ulink" (RS-485) bus, independently from a computer network. ulink support the connection of 16 Station Deluxe (8x SO2R or 16x single operator in any combination). Each Station Deluxe can also access 128 ulink modules. The ulink port supports cable lengths of up to 1.2 km using a standard CAT5 cable, enough to connect a multi-operator station including the antennas comfortable.

ulink interface are small, remote-controlled, multi-functional. This interface are used as relay outputs, RS232 module, rotor controllers, stepper motor controllers, etc. used also to control devices such as remote antenna switches, stack switches, Beverage switches, rotator motors, matching networks, and more. The Station Deluxe includes a locking system, which is programmed by the user. With this system it is possible to distribute all the terminals to each other so that there will be no damage or collisions.

a interfaccia USB-II della microHAM e' un interfaccia USB CAT e soundcard. Questa interfaccia dispone dell'usuale converitore di livello per quasi tutte le interfacce CAT ,e' isolata elettricamente per il PTT e il CW keying, un ingresso per il segnale di squelch e l'isolamento elettrico per le interfacce audio.Tutto cio' fa' di questo dispositivo l'ideale epr tutti gli urilizzatori che vogliono lavorare i modi digitali tramite la soundcard.

Il dispositivo microHAM USB-II lavora con tutti i computers con interfaccia USB. microHAM USB Device Router e microHAM Device Configurator sono compatibili con tutte le versioni a 32bit e 64bit di Windows 7, Windows 8, Vista, XP, 2000 e 2003.

A differenza dei normali computer sul mercato per gli "USB to Serial adapters" le nostre interfacce USB sono progettate accuratamente per la massimma immunita' da forti segnali RFI e al tempo stesso sono "RF quiet".Ogni linea dati e' filtrata passa basso per la minima interferenza.Il solo prodotto del clock del chipset USB e' un beat a 144.030MHz.

• No e' necessaria nessuna porta com o LPT ,solo una porta USB e una sound card
• Isolamento elettrico completo tra "Computer <-> Radio"
• Integrated computer control port per tutte le radio CI-V, FIF-232, IF-232, RS-232
• Squelch input per segnalazione al computer
• Non e' richiesto un adattatore di potenza esterno
• Forte immunita' da RFI
• Connettori quick change
• Drivers for all version of Windows, incl. Windows Vista® and Windows 7 32/64-Bit. Support for Windows7 64-Bit is included since version 7.6.1.
• LEDs per un immediato feedback visivo del CAT, CW, PTT, SQL
• Contenitore in Metal/Aluminum , verniciato a polvere lucida
• Firmware/software upgrades gratis e illimitati via internet

The USB-III CAT interface contains an own soundcard, which is connected via USB to the computer. So you don't need separate audio cables to the computer anymore, the original sound card of your computer remains free for other applications. The sound card of the USB-III device offers two distinct advantages over standard cards: a lower noise level and a higher dynamic range (typ. 87dB). This makes this sound card much more suitable for demanding amateur radio applications. All connections to and from the computer and radio are isolated either by transformers or optically. Control lines exist for CAT, PTT, CW/FSK and Squelch.

The USB-III interface works with all computers with USB connector. microHAM USB Device Router e microHAM Device Configurator sono compatibili con tutte le versioni a 32bit e 64bit di Windows 7, Windows 8, Vista, XP, 2000 e 2003.

The RIGblaster Blue interface upgrades every transceiver with Bluetooth® - not only for digital modes!

Like with other RIGblaster devices, RIGblaster Blue is simply connected to the microphone jack of a transceiver. Individual settings of the microphone jack are configured with the brilliant 'ISC' connectors (7 units included) in a matter of seconds, without technical knowledge! And simple as that almost any standard transceiver has all possibilities that Bluetooth® offers. Connect a PC, a tablet computer or a smartphone via Bluetooth® to a radio to operate digital modes. Or use a BT headset for regular Fone traffic with a radio. The RIGblaster Blue makes it possible!

The integrated Bluetooth® interface in the RIGblaster Blue provides an interface for both audio and CAT data. The audio streams are transferred in transmit and receive direction. The two BT profiles 'HSP' and 'HFP' offer a very comfortable way of using the radio with a BT headset. On the computer those two profiles show up as an external sound card. The CAT interface is presented as a virtual serial port and can be use by practically any log software and multimode programs. CAT systems of virtually every well-known manufacturer are supported. The range of the Bluetooth® signal is about 10m due to the good internal antenna. With this the RIGblaster Blue interface is well suited for the use on a sailing boat, caravan and in the spacious shack.